Headphone volume and Mic/PC Mix answer different questions on Wave XLR. Turning up the output does not necessarily bring back computer audio excluded by the blend.
Elgato’s Wave Link settings overview separates Output Volume from Mic/PC Mix. The latter balances the microphone and computer audio in the onboard headphone port. The document now includes a notice that Wave Link 3 has a different interface from the older version illustrated.
Trace the listening route
First identify which headphone jack is being used. Then identify the selected computer output and the relevant mix control. A microphone with its own USB headphone socket is another signal route; an XLR connection does not make every socket in the setup interchangeable.
Use a modest listening level and a familiar short audio source. Check whether you hear the microphone, the computer or both before changing multiple settings. Write down the working selection so the next session does not begin with the same guesswork.
Match the instructions to the actual Wave XLR generation and installed software. This article describes the control’s purpose, not a promise that every current interface presents the same slider at the same location.
We would investigate routing and balance before buying replacement headphones. Documentation read 25 October 2026. No electrical repair, phantom-power instruction, audio-quality comparison or hands-on latency test. More buying guides.
Leave a Reply